Documentation-first supply · ISO 9001 · FSSC 22000 · Kosher · Halal
Analytical · 6 min read

Why 98% HPLC is not the same as 98% purity

Published 29 October 2026 · ALVORA technical desk

“98% by HPLC” is the most quoted and least examined phrase in ingredient procurement. It describes a detector output at a point in time. It does not describe what the other two percent is, and it does not describe what else is in the drum.

Area percentage is a relative number

Area normalisation adds up every peak the detector sees and reports the analyte as a share of that total. It assumes two things: that all peaks are related to the analyte, and that they respond to the detector in proportion to their mass. Neither assumption is safe with a UV detector at 254 nm.

An impurity with no chromophore at that wavelength is invisible. A co-eluting isomer can be counted as product. A salt or a carrier does not appear at all. The number can be high and the material can still be diluted, contaminated or misidentified.

Four things hiding behind the percentage

  • Carriers and diluents. A 98% extract diluted 1:5 with maltodextrin can still be reported as 98% if the assay is run on the concentrate before blending — or if the assay is calculated on the marker rather than the whole powder. Ask for the dilution statement and the as-is assay.
  • Water. Karl Fischer moisture is not part of the HPLC area, but it is part of the weight you buy. A 98% HPLC result with 6% water is not 98% of what arrives.
  • Isomers and related substances. This is where “purity” is actually defined. Ask for the impurity table, not a single number: which peaks were identified, which were not, and what the reporting threshold was.
  • Residual solvent and ash. Neither appears in a UV chromatogram, and both count against your formulation weight.

The three questions that fix the ambiguity

What is the method? Column, mobile phase, wavelength, flow, run time and standard. A method reference such as “in-house” is not a method.

What basis? Dried, anhydrous or as-is. This alone changes the effective actives you receive by several percent.

What is the impurity specification? Any single unspecified impurity above 0.1%, total impurities, and the identity of the largest two. A supplier who cannot answer this has not characterised the material — they have run a chromatogram.

Rule of thumb. For a 98% HPLC product, expect a total impurity specification of ≤ 2.0% with no single unknown above 0.1%, moisture ≤ 1.0%, and a stated carrier content of zero. If any of those is missing, the 98% is a marketing number rather than a release limit.

What a written specification looks like

Both of our P0 peptide pages show the full release table rather than a headline figure: Tirzepatide ≥ 98.0% HPLC with peptide content ≥ 85% and total impurities ≤ 2.0%, and Copper tripeptide-1 (GHK-Cu) ≥ 99.0% HPLC with copper content bounded to 2.4–3.0%. Every field is released against, not estimated. The same logic applies across the catalogue.

Keep reading

Two more notes from the technical desk.

Quality · 7 min

Reading a botanical COA: the six numbers that actually matter

Assay method, moisture, ash, metals, solvents and sampling — field by field.

Regulatory · 8 min

EU cosmetic compliance: what a non-EU supplier must hand you

The ingredient file, the responsible person, and where supplier documents usually fail.

WhatsApp